Posts Tagged ‘spray foam insulation’

Power bill update

Wednesday, May 19th, 2010

Now that we have been in the house for 10 months, we thought it was time to post our monthly power bills:

July 2009 $55
Aug 2009 $52
Sept 2009 $42
Oct 2009 $63
Nov 2009 $90
Dec 2009 $123
Jan 2010 $98
Feb 2010 $90
Mar 2010 $61
Apr 2010 $46

As you can see, we’ve been able to keep the bills pretty low. To contextualize these bills, it is helpful to know what draws electricity in the home:
- geothermal HVAC
- washer
- dryer (only when it is not sunny)
- dishwasher
- water heater (only when it is cloudy and the solar thermal is not working)
- disposal
- pumps for the rainwater collection system
- household appliances (hair dryer, toaster, water kettle, computers, TV)
- ceiling fans
- lights (all equipped with flourescent bulbs)

We also have more or less stuck with the default EnergyStart thermostat settings for the geothermal, which means

Heating;
68 degrees from 6:30am to 8am and 5pm to 10pm
62 degrees at all other times

Cooling
78 degrees from 6:30am to 8am and 5pm to 10pm
85 degrees at all other times

The house itself is two stories and covers about 1800 square feet. As previous posts indicated, the house was also newly insulated with spray foam insulation in all exterior walls on both floors and 12″ of cellulose on the attic floor. Spray foam was not used along the roof line. We also had new double-pane Integrity windows installed throughout the house (more on those in another post). These insulating features have no doubt played a big role in keeping our energy bill down, too.

Unfortunately, we do not have any real points of comparison because the house did not have heat or air when we moved in.

Siding a success

Thursday, April 29th, 2010

As an earlier post indicated, we decided to have all the old pine siding removed in order to install spray foam insulation around the entire house. That step of the process went smoothly, but we were concerned that the old siding would not be up to the task of being put back on the house. After lying stacked up in the backyard all summer and beginning to look a bit forlorn, the siding’s time had come. We started the process by priming the one side of the siding that had been exposed to the elements for those many years. Then, the siding was put back up on the house over the spray foam insulation with the primed side facing in. That left the unprimed side - the side that had been facing in for the life of the house - facing out and ready to be primed and painted itself. Our concerns about the siding becoming warped were unfounded; we were able to re-use just about all the siding and needed new siding on just one small exterior wall to make up for the few pieces that had cracked or were too worn to re-use. In the end, all our discussions and research about how best to insulate the house (drill & fill from the outside; remove plaster walls on the inside and spray in insulation; remove siding and replace with new siding or Hardiplank), we’re very happy with the decision to have the siding removed. We got the spray foam insulation we wanted and we were able to keep the great, old siding that you just can’t find anymore. We’re even fortunate to have a few pieces of siding left over that we’re hoping to turn into bookcases and shoe racks.